No Heat Regenerative Adsorption Drying Machine

According to the principle of  voltage transformation adsorption, with special affinity for water vapor of adsorbent , adsorption of moisture in compressed air. This equipment is made into the twin towers structure, under the control of the program controller, two tower work alternately, a tower under the high pressure absorbing moisture, another tower under low pressure using the preparation of the dry air itself to complete the steam stripping process, continuous cycle to work.
                       Conditions of use:                        
                      1. Installation site: the ground is flat, without foundation, 80 cm distance from the wall.
                      2. Installed environment: well ventilated and has no dust, no oil pollution.
                      Working conditions:                        
                      1. The inlet pressure: standard 0.7 Mpa ≦ 1.2 Mpa
                      2. Regenerative way: no hot regeneration
  3. The inlet temperature: ≦ 40 ℃
  4. The inlet oil content: < 0.1 PPM
                      5. Inlet temperature: ≦ 45 ℃
                      Common parameters:
                      1. The finished product angry dew point: - 40 ℃ ~ 70 ℃
2. Switching cycle: 10 min is adjustable
3. The regeneration gas (15 ~ 18) % capacity
4. Control modes: single chip microcomputer automatic control program
5. The pressure loss: ≦ 0.02 Mpa
6. Power supply: AC 220 v, 50 hz
7. Adsorbent: activated alumina (Al2O3) or molecular sieve (13 x)