Power UNITS FOR LIFT TABLE 1
Basic Description
This electrical power unit is made solely to the smaller lift table,Consisting of higher pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This electrical power unit has been widely utilised in the sector of logistic units for example minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is controlled from the solenoid valve with all the velocity managed through the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
General Description
This energy unit is intended solely for your medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve as well as the speed managed by the adjustable needle valve. Once the lift rises to a substantial positoin, however the power supply is reduce, the lowering motion is managed through the manual override function.
Power UNITS FOR LIFT TABLE three
General Description
This power unit is created solely for the huge lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve plus the speed managed by a pressure compensated flow control valve.
Energy UNITS FOR LIFT TABLE 4
Common Description
This power unit is made exclusively for that huge lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve and the pace managed from the adjustable needle valve. Once the lift rises to a high positoin, but the power provide is lower, the reducing motion is managed by the guide override function.
Specific Notes
one. This energy unit is of S3 duty cycle, which might only work intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean the many hydraulic components concerned prior to set up of the energy unit.
three. Viscosity in the oil shoud be 15~46 cst,which should really also be clean and totally free of impurities.N46 hydraulic oil is recommended.
four. Oil modifying is needed just after the preliminary one hundred operation hrs,afterwards after each and every 3000 hrs.
5. The power unit proven is built to be mounted vertically.