FMM Type Mill Couplings
The FMM Variety coupling consists of 1 conventional flex hub, 1 universal straight bored hub as common, two sleeves and a single accessory kit. This coupling is provided with exposed bolts as common. Shrouded bolts can be found on request as a result of dimension five.5.
Functions
For prolonged daily life
Conventional 20° pressure angle
Heat handled bolts for higher strength
Corrosion resistant bolts and nuts for ease of maintenance
Delivers parallel, angular misalignment and finish float
Flex Half coupling interchangeable with business requirements
Long Universal Hub provided to buyer specs with straight or tapered bores
Ordering Data
Application: Driver and Driven.
Form and size of coupling, horizontal, vertical and so on.
Electrical power: Motor horspower or torque requirement.
Pace: Motor RPM or Driven RPM.
Distance amongst shaft ends (BSE).
Shaft sizes.
Taper per foot and length of taper if tapered bore is needed.
Specify counterbore dimensions if wanted.
Submit a drawing if readily available.

FHDFS Variety Floating Shaft Couplings
The FHDFS Type coupling includes two flex-rigid couplings and one floating shaft. The coupling is supplied together with the rigid hubs outboard unless of course otherwise specified. The coupling includes exposed bolts only.
Capabilities
Flex Hubs for extended daily life
Standard 20° strain angle
Heat taken care of bolts for higher strength
Corrosion resistant bolts and nuts for ease of maintenance
Accommodates parallel and angular misalignment
Removal of center assembly permits forease of servicing with out repositioning machinery
Rigid hubs outboard will allow for bigger shaft diameters
Intended for high-torque low-speed applications that come about in mill operations
Ordering Facts
Application: Driver and Driven.
Form and dimension of coupling, horizontal, vertical and so forth.
Electrical power: Motor horspower or torque requirement.
Velocity: Motor RPM or Driven RPM.
Distance in between shaft ends (BSE).
Connecting gear shaft sizes.
Specify which hubs are to be employed to the products (Rigid or Flex).
Rigid hubs will probably be utilized within the products unless of course otherwise specified.
Length of floating shaft may impact max angular misalignment.