Spiral bevel gears are usually created from hardened steel. One’s teeth of these gears are often ground for a far more precise finish allowing for little noise at high speeds. You can specify left hand or right hand based on the direction you have to run the gears

If you have a high speed application that requires a lot of torque after that spiral bevel gears certainly are a great choice. The gears operate at 90° to one another and have “spiral” shaped teeth which provides maximum tooth surface get in touch with while rotating. With contact spread over the whole tooth the spiral bevel gear could be run much quicker than the straight tooth bevel equipment and handle harder starts and stops.

We make spiral bevel gears limited to industrial applications.

Worm gears are found in large gear reductions. Gear ratio ranges of 5:1 to 300:1 are common. The setup is designed to ensure that the worm can change the gear, but the equipment cannot change the worm. The angle of the worm can be shallow and because of this the gear is held set up because of the friction between your two. The equipment is situated in applications such as for example conveyor systems where the locking feature can act as a brake or an emergency stop.

The model cross-section shows an average placement and usage of a worm gear. Worm gears possess an inherent basic safety mechanism built-in to its style given that they cannot function in the invert direction.